Products · De 35–45 mm
Slim aluminium aerosol cans, De 35–45 mm.
The narrowest of the three bands. De 35–45 mm covers deodorant, body spray, dry shampoo and other small-fill formats where the can is part of the shelf presence. Height is chosen from the plant range of 88–240 mm, and the fill volume follows from De × H3.
Fits personal care formats filled at under 100 ml — deodorant, body spray and dry shampoo. It does not fit industrial formulations needing a wide valve cup: at 35–45 mm the interface is 1″ (25.4 mm) or 20 mm, nothing wider.
What products fit this band?
Anything where the fill is small and the can is handled at arm's length. The narrow body holds less, so a single unit carries fewer millilitres — which is why this band is common in personal care and in compact household formats rather than in industrial aerosols.
- Deodorant and antiperspirant, including compact formats
- Body spray and dry shampoo
- Small-fill household and air-care products
- 20 mm compact valves are most often used on these diameters
What is fixed in this band and what is decided per order?
The band fixes the diameter. Everything else is a decision per size, and the ones still open stay marked TBC rather than being filled with an average.
| Parameter | Position in this band | Status |
|---|---|---|
| Body diameter | 35–45 mm | Confirmed |
| Can height | Chosen within the plant range 88–240 mm | Usable height per size TBC |
| Capacity (C2) | Derived from the chosen De × H3 | TBC per size |
| Internal coating | Selected against your formula | TBC per formula |
| Up to 8 colours on the body | Confirmed | |
| Valve interface | 20 mm or 1″ (25.4 mm) | Confirmed |
| Minimum order | Confirmed with the quotation | TBC |
Question about your spec?
Send the body diameter and the product you are filling. We answer in writing, usually the same working day.
Why does print quality matter more on a narrow can?
On a slim body the printed area wraps faster, so a small registration error is visible from more angles, and a design that reads clearly on a 55 mm body can turn to mush at 35 mm. Artwork is checked against the actual circumference before a sample is made — minimum line weight and trapping first, colour sequence second.
What do we need before quoting?
- Body diameter and can height, or the fill volume plus the product type
- Valve interface — 20 mm or 1″ — and the valve you already run, if there is one
- Product type, solvent system, propellant and storage temperature, for the coating
- Artwork status: print-ready, or still in design
If you are not sure whether the size sits in this band or the next one, send both numbers. The band is a grouping for tooling, not a rule that rejects a size near a boundary.
Questions
Questions about slim cans
Is De 35 mm the smallest diameter you make?
35 mm is the lower end of the confirmed body diameter range. Sizes below it are outside the published range, so they are not quoted until the factory confirms the tooling.
Can a slim can carry a 1″ valve as well as a 20 mm one?
Both interfaces are available. The 20 mm compact valve is the more common choice on these diameters, because the smaller cup leaves more room on the shoulder for print.
What fill volume does a De 35–45 mm can hold?
It depends on the height, which is why the capacity is marked TBC per size rather than published as a band. Send De and H3 and the brimful figure is confirmed for that exact combination.
Not answered above?
Ask the question directly — one line is enough to start.
Next
Other diameter bands
Send the specification you have. We will fill the gaps.
Body diameter, can height and valve interface are enough to start. Anything you do not have yet we ask for once, in writing.